Skip to content
TroubleshootingBy Water Heater Repair in Honby, CA

Water Heater Leaking: What to Do Before You Call

Shutting the water off, working out where the leak is actually coming from, and the difference between a leak that is a part and one that is the tank itself.

A leaking water heater is a water problem before it is an appliance problem. The order of the next twenty minutes matters more than diagnosing the cause.

First, stop the supply

The cold inlet valve is on the pipe feeding the top of the tank. Turning it clockwise until it stops prevents more water entering, which is what limits how much reaches the floor. Water already inside will still drain out, so move anything valuable off the floor while it does.

If the valve is stiff or will not close, do not force it to the point of breaking. Call and describe that, because it changes what happens next.

Second, remove the energy

Turn off the gas valve on the supply pipe if it is reachable without touching water. On an electric unit, switch the breaker at the panel. Heating an emptying tank can damage it further, and a burner running with water around it is a hazard.

A gas smell overrides this sequence: get everyone out, then ring the utility's emergency line from the street.

Third, work out where it is coming from

Where the water appears is the most useful clue you can give anyone.

At the base of the tank, with rust. The shell has failed. This is not a repairable part, and the unit is a replacement.

At a fitting or union on top. A connection has worked loose, corroded through or failed at the thread. Usually a serviceable repair.

At the drain valve. The valve itself is leaking, which is a part rather than a tank failure.

At the relief valve or its discharge pipe. The temperature and pressure relief valve is opening, or it has failed. Do not cap it. The cause is pressure, temperature or the valve itself.

Under a cold tank, in humid weather. Condensation, which looks alarming and is not a leak from the vessel.

At the flue collar or on top of the tank. This can be a venting or condensation issue and deserves prompt attention.

Fourth, contain and dry

Catch what you can with buckets and towels, and leave a wet vacuum for water that is nowhere near wiring. Ventilate the space. If a claim is likely, take photographs before anything is tidied away. Water that has crept beneath a floor covering or into a wall cavity stops being a plumbing job and becomes a drying and restoration one.

When it needs a call now

Water that keeps running, water within reach of outlets or a panel, a relief valve that will not stop discharging, any gas odour, or a tank that has visibly split. In each of those, calling overtakes investigating. The emergency page lays out the shutdown order.

When it can wait for daylight

A dripping drain valve with a container under it, a weeping union, condensation, and a tank that is damp but not running. Those are repairs, and the repair page explains what each one involves. If the shell has gone, the replacement page is the honest next step.

Get in touch

Find the source, not the puddle

Say whether water appears at the tank base, a fitting, the relief pipe or the flue. That one detail decides whether it is a part or a replacement.

Questions about this article

How do I stop the leak right now?

Close the cold inlet valve on the pipe feeding the top of the tank, then shut off the gas valve or the breaker if it can be reached safely.

Water at the base of the tank — is that always a failed tank?

Not always. Condensation, a leaking fitting above, or a failed relief valve can put water there. A wet base with rust and a leaking shell is the case that cannot be repaired.

Can I use the heater with a small leak?

No. A leak that reaches electrical components or the burner is a hazard, and a slow leak on a tank usually grows. Shut it down and have it assessed.

Call+1 989 601 2666