Skip to content

Specialty

Tankless water heaters

How tankless units differ from storage tanks, what sizing and venting demand, why scale matters, and where the cost actually sits.

Hours
Open 24 hours, every day
Service area
Honby, California
Services
7 types

A tankless heater heats water as it flows rather than storing it hot. That single difference ripples through sizing, venting, gas supply, maintenance and price, and it is why a tankless conversion is closer to a new installation than to a swap.

How the unit works

Cold water passes through a heat exchanger fired by gas or heated by electric elements. Output is rated by flow at a given temperature rise: the colder the incoming water and the higher the target temperature, the lower the flow the unit can sustain. Two showers running together is a flow question, not a tank-size question.

Sizing by flow, not by gallons

Storage tanks get compared by volume; tankless units get compared by capacity. The useful inputs are the number of outlets likely to run at once, their flow rates, and the incoming water temperature in the coldest months.

An undersized unit shows its limits as temperature swings when a second tap opens, or as water that never reaches the setpoint in winter. An oversized unit costs more and may not modulate well.

Venting, gas and condensate

Tankless venting is model-specific: Category III stainless for many non-condensing units, Category IV PVC or CPVC for condensing models, with maximum lengths and termination rules set by the manufacturer. The vent cannot simply reuse the old tank's flue.

Gas supply is the other common constraint. A tankless burner can demand more than the line that fed a tank, so the line may need upsizing. On the electric side, the panel capacity is the equivalent question.

Condensing units produce acidic condensate that must be drained or neutralised according to the installation instructions. It is a small detail that is easy to omit and expensive to retrofit.

Scale and maintenance

The heat exchanger is the part that fails or loses performance. Scale insulates it, reduces output and eventually blocks flow. Descaling on a schedule is the tankless version of flushing a tank, and it matters more in hard water.

Where the cost sits

Tankless equipment costs more than a storage tank, and the installation tends to involve more: venting, gas work, sometimes electrical work and condensate. The running-cost benefit comes from avoiding standby losses, so a household that uses hot water in short bursts sees less of it than one with steady demand.

The installation page covers the general conditions, and replacement covers the decision to change type. Coverage runs across the fourteen places this site serves.

Tankless Water Heater service areas

How coverage is decided

Get in touch

Tankless sounds good. Will it fit?

Call with the number of bathrooms and the fuel type. Flow rate and gas capacity decide whether a tankless unit suits the house before price does.

Questions about this service

Does a tankless unit really last longer?

Manufacturers commonly put tankless life at fifteen to twenty years against eight to twelve for a tank, and both figures assume maintenance. Scale removal is the tankless equivalent of flushing a tank.

Will a tankless unit save money?

It can reduce standby losses, because there is no stored tank cooling between uses. Whether that offsets the higher equipment and installation cost depends on how the hot water is used.

Can one tankless unit serve several bathrooms at once?

Only if its flow capacity covers the combined demand at the incoming water temperature. Two showers and a running tap can exceed a small unit, and that is a sizing question, not a fault.

Does tankless work with hard water?

It works, but the heat exchanger scales faster. In hard water areas, descaling becomes a regular maintenance item rather than an occasional one.

Call+1 989 601 2666