A tankless unit solves a specific desert problem: hot water without a tank sitting hot and a long pipe run losing heat. It also asks more of the water and the weather.
The inlet filter works harder
Unlike a city supply, basin water arrives with sand and silt in it. That material meets the inlet filter first, which protects the flow sensor and the exchanger but fills up fast. A pre-filter upstream and a cleaning routine keep the unit firing.
Ice in the exchanger
Water stays in the exchanger between draws. In an unheated shed, or on a wall that takes the wind, a hard freeze splits it, and that is normally the end of the appliance. A space kept above freezing, insulated runs and an indoor position are what actually prevent it.
Descaling on local water
Hardness varies with the basin and the season. Scale reduces temperature at high flow and eventually triggers codes. Service valves fitted at installation make descaling practical.
Gas and altitude
Tankless units draw a high input while firing. The gas supply has to carry it, and the appliance must be rated for the elevation, or combustion runs rich.
Point-of-use makes the case
A workshop, a guest room or a distant bathroom is where a small unit earns its place. It heats only what is used, needs no recirculation, and avoids a run that would otherwise freeze.
Repair limits
Filters, flow sensors, igniters and boards are replaceable. A cracked or heavily scaled exchanger usually is not, which is why protection matters more than the warranty.
The maintenance page covers the routine, and the installation page covers siting.