Tankless units suit this neighbourhood for reasons that have little to do with fashion: the houses are large, the mechanical space is tight, and a wall-mounted unit frees a closet that a tank was occupying.
The gas question comes first
A tankless heater fires at a much higher input than a storage tank. Gas piping installed in the 1950s or 1960s was sized for the appliance of that era, so the supply often needs work before a tankless unit can be considered. On a hillside property the meter location and the run length both matter, and this is settled by measurement rather than by the unit's specification sheet.
Venting and condensate on a single-storey house
Broad, low roofs limit vertical venting, so a side-wall termination is the usual route. Clearances to windows, doors, the property line and the neighbouring structure decide which wall works. Condensing units also produce acidic condensate that has to be neutralised and drained, and on a graded pad the discharge point has to be somewhere it will not stain or undermine anything.
Scale is the maintenance story
Beverly Hills reports average hardness from roughly 81 to 262 mg/L across recent years, which puts the supply in hard to very hard territory. Scale collects in the heat exchanger, reduces temperature at high flow and eventually triggers error codes. Descaling on an interval set by the measured water, not by a generic schedule, is what keeps output where it should be.
Repair or replace the unit
Error codes point at a category, not a cause: flow, flame, exhaust or sensor. A dirty inlet filter, a scaled exchanger, a failed flow sensor, low gas pressure and a blocked condensate line can all present the same way. The exchanger is the expensive component, and where it has been damaged by freezing or heavy scale, replacement can be the better spend.
Retrofitting an original closet
A tankless unit in the space a tank occupied works when the gas, vent and condensate routes can be resolved. Where they cannot, the unit moves to an exterior wall or a garage, which changes the pipework but often gives a cleaner installation. Both options are worth costing before choosing.
For the storage-tank alternative, the replacement page covers a like-for-like swap and the installation page covers a new unit in a rebuilt house.