Hollywood is mostly a renter's neighbourhood by building type: roughly four in five homes sit in multiple-family buildings, so a water heater here is often one unit inside a larger system rather than a tank in a garage.
What fails in these buildings
Elements and thermocouples. The ordinary consumables, and still the most common reason a unit goes cold.
Scale. LADWP's central-area average is around 168 mg/L, which is hard. Sediment settles on the tank floor, recovery drops, and the bottom of the tank runs hotter than it should.
Dip tubes and aged pipework. In older buildings the cold inlet tube can break, so hot water runs out within minutes of starting a shower. The heater is working; the water is short-circuiting.
Recirculation faults. Buildings and renovated houses with hot-water loops can lose hot water at the tap while the heater itself is fine, which is a pump or control problem rather than an appliance one.
Shared shut-offs. A repair that needs the water off can affect neighbouring units. Finding and labelling the right valve before the visit is half the scheduling.
Repair or replace
A failed part on a sound tank is a repair. A tank leaking at the shell, a rusted base, or a unit that has taken several repairs in a short period is a replacement. In a building, the decision also has to account for access: replacing a heater in an upper-floor closet is a different job from swapping one at ground level.
What the call needs
Whether the heater serves one unit or the building, what the symptom is, the fuel type, where the unit sits, and where the shut-off is. If hot water has failed in several units at once, say so: that points at a shared system rather than one appliance.
If water is running, close the supply first: the emergency page sets out the order. If the tank has failed, replacement covers removal and the permit.