A working property on this hill might be a workshop, a boarding stable, a small guest operation or a house with three outbuildings. What they share is a peak demand that arrives all at once and no patience for a cold tap.
Read the peak, not the tank
The useful number is how much hot water the busiest hour consumes, and at what temperature. A generous tank behind a modest burner stores heat but cannot keep up when several outlets run together, and that is the shortfall people describe as "running out".
The supply is the limit
Before equipment is chosen, the water source is measured. A well's yield, how much it stores and how quickly it recovers decide what the property can actually support. Where water is hauled, storage and leak-free connections matter more than flow rate.
One roof per unit
Buildings that stand apart are usually better off with their own heater. A single unit serving several means long runs that cool and freeze, and one failure that stops everything.
Wind and exhaust
On an exposed site, a flue termination that works in still air may not draft in a gust. Grit also collects in burner compartments. Both are reasons to check the venting rather than assume it.
Cold buildings
An unheated barn or guest unit will freeze, and no appliance survives that repeatedly. Insulation and trace heating, or moving the unit somewhere warmer, are the real fixes.
The hours you can lose
How long the operation can go without hot water decides whether work happens after closing, before opening, or in stages.
Parts versus vessels
Wear parts are replaceable; vessels are not. Controls, burners, elements, valves and expansion tanks can all be renewed, while a failed shell or exchanger ends the unit, and equipment bought together tends to reach that point together.
The emergency page covers a failure in progress, and installation covers a new specification.