Replacement on a mountain parcel is a chance to correct the two things that end tanks here: water that carries grit, and nights that freeze.
What killed the last one
Grit from the well. It collects on the floor, holds heat back and eats at the base from the inside. Ice. A split line, a split fitting or a cracked exchanger. If the old tank lived in an unheated space, start there. Neglect. An anode spent years ago, and a lining that has been failing quietly ever since.
Choosing what goes back
Staying with the same type keeps the flue and the location as they are, which is the least disruptive route when demand has not changed. A different type earns its place where the old unit sat in a cold space or where stored water is scarce.
Whichever is chosen, the installation should include the protection the old one lacked: insulation, heat trace where runs are exposed, a filter ahead of the heater, and a location that stays above freezing.
Water is precious here
On hauled or limited well supply, a leaking tank or a weeping relief valve wastes water someone had to bring in. Fixing those is part of the replacement rather than a follow-up.
Removal and access
A drained tank on an unpaved drive is a different carry from one beside a garage. Grades, gates and the distance to the road are worth describing when the visit is booked, because they decide how the removal is staffed.
Altitude and the new appliance
If the replacement is a gas unit, confirm it is rated for this elevation and has the right orifice. A sea-level appliance installed at 4,300 feet will soot and spill.
The county permit
Los Angeles County issues and inspects the permit. The inspection covers venting, clearances, relief discharge and seismic strapping, which matters on a parcel near the San Andreas Fault.
The installation page covers a new install in detail, and the maintenance page covers keeping this one alive.