Replacing a heater at the desert edge is an opportunity to fix the conditions that ended the last one, because the same water and the same winter will meet the new unit.
Two causes account for most failures
Grit. Basin water carries material that settles, insulates and corrodes. A tank that fails at year seven usually has a floor full of it.
Ice. A split line or a cracked exchanger after a hard freeze. If the old unit sat in an unheated space, that exposure is the thing to correct.
What to put back
Matching the old type keeps the flue and the position, which is the least disruption where demand has not changed. Changing type is worth it where the old unit sat in the cold, where space is tight, or where stored water is limited.
Whichever way it goes, the installation should include what the old one lacked: a filter ahead of the unit, insulation on exposed runs, and a location that stays above freezing.
Water you cannot waste
Where supply is hauled or a well is slow, a weeping relief valve or a leaking tank wastes water that took effort to obtain. Those are fixed as part of the replacement, not deferred.
Removal over rural access
Dirt drives, gates and distance from the road decide how a drained tank travels. It is emptied first, then moved to the vehicle. Access is worth describing at booking.
Gas and altitude
A replacement gas unit must be rated for the installation altitude and fitted with the right orifice. An appliance set up for low elevation soots and can spill here.
Inspection
Los Angeles County inspects the finished work, covering the flue, clearances, relief discharge and seismic strapping.
The installation page covers a new unit, and the maintenance page covers protecting this one.