Installation at this elevation is a cold-weather design problem before it is a plumbing one. The appliance matters less than where it sits and what happens to it in February.
Freeze protection comes first
An unheated garage, an exterior closet or an outbuilding will freeze. Pipework needs insulation, exposed runs often need heat trace, and a tankless exchanger needs the space kept above freezing. A unit installed without that plan is a repair waiting to happen.
Altitude and gas rating
Gas water heaters are certified for a range of installation altitudes, and above the certified range the orifice has to change. At 4,300 feet a sea-level unit soots, burns lazily and can spill. The rating plate is checked before the unit is ordered, not after.
Water supply and storage
On a well, sediment and pressure shape the installation: a filter ahead of the heater, and a check of the pressure tank and pump setting. Where water is hauled, storage capacity and leak-free connections matter more than flow rate.
Venting and clearances
Hillside wind and snow load affect termination. A vent that draws well on a calm day can spill in a gust, and a termination buried by snow is a hazard. Clearances to combustibles and to the roofline are settled early.
Fire-conscious siting
The community sits in very high fire hazard severity zones. Equipment placement, clearances and access for maintenance are planned with that in mind, and nothing is stored against the appliance.
Sizing the house
Large lots often mean a main house plus a guest room, a shop or a manufactured home. A separate unit at the outbuilding usually beats a long, freezing-prone run.
Permits and strapping
Los Angeles County permits and inspects the work. California also requires storage tanks to be braced against seismic movement, and the San Andreas Fault runs through this area, so the strapping is not a formality.
The replacement page covers a swap, and the tankless page covers on-demand units and their freeze risk.