Installation in a canyon community is an access and exposure problem before it is a plumbing one. The appliance is chosen once the site has been read.
Reading the site
Where does a full tank have to travel? Narrow canyon roads, steep driveways and steps decide how the unit arrives and how the old one leaves. A crawl space under a raised cabin, a closet on an exterior wall and a shed each carry different requirements.
Water supply
A private well or a small system supplies the house, and both bring their own pressure behaviour. A filter ahead of the heater is worth considering where grit arrives, and the pressure is checked so the appliance is not fighting surges.
Venting
The flue has to suit the appliance and the location. On a slope, a side-wall termination may be simpler than a roof penetration, subject to clearance from windows, doors and the property line.
Frost
Any unheated location needs protection: insulation on the runs, heat trace where exposed, and a space that stays above freezing. A tankless unit needs that most, because water sits in the exchanger.
Gas at this elevation
A gas appliance must be rated for the site and fitted with the correct orifice. At roughly 2,500 feet a low-elevation setup can soot and spill.
Inspection and strapping
The county inspects the finished work, covering the flue, clearances, the relief valve discharge and the seismic strapping a storage tank requires in California.
A straight swap is on the replacement page; on-demand units are covered under tankless.