In a desert community, the installation decision that matters most is not the appliance. It is where the unit sits and what happens to it in a cold snap.
Freeze protection
Water expands when it freezes, and a heater holds water. An outdoor closet, a garage or a shed needs insulation on the pipework, and often heat trace on the exposed runs. A tankless unit is more exposed still: water sits in the exchanger when the unit is idle, and a hard freeze can crack it.
Options include keeping the space above freezing, choosing an indoor location, or specifying a unit with built-in freeze protection and accepting that it is not a substitute for a heated space.
Hard water and specification
The groundwater here averages around 140 mg/L of hardness, which is hard. Nothing about that rules out a tank, but it argues for a maintenance plan from day one, and it makes descaling a required routine on a tankless unit rather than an optional one.
Venting in wind
Desert wind affects draft. A vent that terminates where wind hits it can spill or back-draft, which is a safety issue rather than an efficiency one. Termination location, clearance and the appliance's venting category are settled before the unit goes in.
Sizing for the property
Rural lots often have a main house, a shop, a guest room or a manufactured home. One unit serving everything means long runs and heat loss; a separate unit at the outbuilding is often the better answer.
Water supply
Where the parcel is on a well, sediment and pressure matter to the appliance. A filter ahead of the heater and a check of the pressure setting are part of a sensible installation.
Permits and strapping
Los Angeles County permits and inspects the work, since the community is unincorporated. The inspection covers venting, clearances, the relief valve discharge and seismic strapping of a storage tank.
The replacement page covers a swap, and the tankless page covers on-demand units and their freeze risk.