Maintenance in the high desert has two seasons' worth of work in it: removing the scale that hard water leaves, and making sure the unit survives the cold.
Flushing for scale
The local groundwater is hard, so mineral deposit settles on the tank floor quickly. That layer insulates the water from the burner, slows recovery and holds moisture against the steel, which is where corrosion starts.
The tank is drained through its valve and refilled until the outflow runs clear. What comes out tells you how often the job needs repeating, and on this water the answer is usually more often than the label suggests.
The anode rod
A sacrificial rod gives up its own metal in place of the steel. Hard water and aggressive chemistry shorten its life, and inspecting it is the only way to know how much protection remains. Swapping a spent rod on a sound tank buys years.
The relief valve
The relief valve protects the tank from over-pressure and over-temperature. It gets tested on every visit, water from its discharge pipe is a fault rather than a nuisance, and it is never capped, however tempting that seems during a cold snap.
Winter preparation
Exposed pipework in a garage or an outbuilding is insulated, heat trace is checked, and the space around the unit is confirmed to stay above freezing. A tankless exchanger left with water in it over a hard freeze is the most expensive failure a desert installation can have.
Combustion and venting
Dust and wind affect burners, flues and combustion air openings. Cleaning the burner compartment and checking the flue are part of the visit, and they are also a safety check.
What maintenance cannot do
It will not repair a failed element, a cracked tank or a split fitting. When hot water has stopped rather than slowed, start with the repair page; where the vessel has failed, replacement is the answer.