Maintenance is the cheapest thing you can do for a water heater in hard water, and this neighbourhood has hard water by the city's own reporting.
Why the interval is shorter here
Beverly Hills publishes average hardness across a range that has run from about 81 to 262 mg/L in recent reports. At the upper end that is very hard, and the practical consequence is a sediment layer on the tank floor that builds faster than a generic annual reminder assumes.
That layer does two things: it insulates the water from the burner or element, so recovery slows and energy use rises, and it traps moisture against the steel, which is where a tank starts to fail from the inside.
Flushing a tank
Drain through the drain valve, refill, repeat until the water runs clear. On a tank that has not been flushed in years, the drain valve itself may not reseal, so it is worth checking before opening it. A tank that rumbles again within weeks of a flush is telling you the deposit is heavy and the unit is closer to the end than its age suggests.
Descaling a tankless unit
The heat exchanger is flushed with a descaling solution, usually through service valves fitted for the purpose. Without them the job is messier and slower, which is an argument for having them installed with the unit.
The anode rod
The rod gives up its own metal so the tank lining does not. In hard water it can be consumed faster than the calendar suggests, and checking it is the only way to know. A spent rod replaced on a sound tank buys years; the same rod after corrosion has started buys very little.
Relief valve, venting and connections
The temperature and pressure relief valve is a safety device and is tested every visit. Water from its discharge pipe is a fault, not a nuisance, and it is never capped. On these houses the vent run is long and often horizontal, so it is checked for corrosion, slope and clearance. Original shut-off valves and connectors are inspected while someone is already at the unit.
What maintenance cannot fix
A failed element, a cracked tank and an undersized unit stay failed, cracked and undersized. When the symptom is no hot water rather than slow recovery, the repair page is the right starting point. Where the tank has already gone, replacement is the honest answer.