A canyon property asks two things of its water heater: cope with what the supply carries, and survive the cold. Maintenance is the visit where both get attention.
What the supply leaves behind
Water from a well or a small system arrives with material in it. That material settles on the tank floor, where it holds heat away from the water and keeps the steel damp. Draining the tank flushes it out, and the amount that comes out says how often the job is worth repeating.
The rod inside the tank
A sacrificial rod sits in the tank to corrode in place of the lining. It is the cheapest thing that decides the tank's lifespan, and it is invisible from outside. Checking it, and renewing it while the tank is still sound, is the difference between a decade and a handful of years.
Valves and pressure
The relief valve is tested because it is the tank's safety device, and water from its discharge is a symptom rather than normal operation. On a pumped supply, the pressure tank and the switch setting affect how hard that valve works.
Before the frost
Exposed runs get insulation, heat trace is proven rather than presumed, and the space around the appliance is checked for how cold it drops. A tankless exchanger left full is the costliest casualty of a cold snap.
Flame and flue
Gas units at this elevation need the right setup, and soot is the tell when they do not have it. The burner, the flue and the air openings are examined, and the flame is watched.
Where maintenance stops
It cannot renew a failed element, seal a split shell or repair a cracked exchanger. When hot water stops entirely, the repair page is the place to start; when the vessel has failed, replacement is the answer.